AutoStop Maxi User Manual Version 8.18
Page 7
3.6 Test Instructions Summary (cont’d)
9
Prelude
The Brake Tester is ready to
start recording. If the vehicle
is at a stop, release the brake
and gently accelerate the
vehicle to the required speed.
Apply the brakes by pressing
on the pedal sensor attached
to the brake pedal (or by
using the emergency brake).
For Service Brakes, the test
is triggered when the pedal
sensor detects a load greater
than 40 Newtons followed by
the vehicle decelerating by
more than 0.1g. (Note: both
must be met). For emergency
brakes, the test is triggered
only by the vehicle
decelerating by more than
01.g. If the vehicle is in
motion, you may gently
accelerate to the required
speed and follow the same
instructions as above.
Calculating ….
If data logger is fitted
screen will display Save
Y/N? Otherwise straight to
Print Y/N?
10
Save Y/N
If the Datalogging option is
not installed, this will not
appear and the LCD will
move directly to “DUPLICATE
Y/N”. If the Datalogging
option is installed, you have
the option to save the test by
pressing “Y”.
Press “Y” or “N”
If the memory is full, it will
not save and will display:
“Not Enough Mem.”. If it is
not full and the “Y” is
pressed, it will save test. If
“N” is pressed, the test will
not be saved. In either case
the LCD will show Print Y/N
11
Print Y/N
Allow the report to be printed.
Press “Y” or “N”
If “Y” the LCD will show
“Official Copy”. The unit
will begin to print and LCD
will then show Normalising
as it calculates data for
graph presentation. As it
prints the graph, the LCD
will show Graph. The LCD
will now show Duplicate. If
“N” the unit will return to
Repeat Y/N
12
Duplicate Y/N
If you require an additional
copy of the test Press “Y”. If
one copy is sufficient then
press “N”
Press “Y” or “N”
If “Y” the display will show
“Customer Copy”, the unit
will begin to print and LCD
will then show Normalising
as it calculates data for
graph presentation. As it
prints the graph the LCD
will show Graph The LCD
will then show Repeat Y/N
13
Repeat? Y/N
Repeat the test by pressing
“Y”, stop testing and return to
Ready mode by pressing “N”
Press “Y” or “N”
Svrc/Emrg? S/E if “Y” is
pressed, Ready> if “N” is
pressed
