AutoStop Maxi User Manual Version 8.18
Page 13
Pedal Sensor
Rated to less then +/- 1N over 0 to 1000N
Accelerometer
Rated to less than + /- 2% over -2.5 to 2.5g
Paper
Wood-free paper
Max roll diameter
50mm
Width
44.5mm (+/-0.5mm)
Thickness
0.06mm (+/-0.001mm)
Basic Weight
52.3gms (14lb/500 sheet 17”x22”)
Ribbon
Epson type ERC-05
Ribbon Life
Equivalent to 3 paper rolls
Print Speed
1.0 line/sec
Colour
Purple or Black
Dimensions
approx. 74mm (w) x 25mm (d) x 7mm (h)
Note: The use of proper paper is very important to the operation of the printer. Use
of non standard paper will jam the printer or wear the print head and will void the
warranty. Paper and ribbons are available from AutoTest Products as a kit,
containing 3 rolls of paper and one ribbon. The replacement of any other
components must be carried out by AutoTest Products or an Authorised AutoTest
Service Center.
8. CHANGING PAPER
1. Switch the Brake Meter “On” and enter Examiner I.D. to get to the “Ready” mode.
2. Remove the printer cover plate on the top of the keypad by inserting a screwdriver
in the buttons and twisting through 90 degrees.
3. Lift out printer cover plate, empty paper roll.
4. Tear off any remaining paper. With the Brake Meter
turned on and at the “Ready” mode, press the “P” key
on the keyboard to feed any remaining paper through
the printer.
5. Press any key to halt paper feed.
6. Remove the old paper core and spindle by gently
springing apart the sides of the paper holder. Discard
the paper core.
7. Prepare a clean starting edge on the new roll by
cutting off the top of the paper.
8. Mount the paper roll on the spindle and load into the
paper holder in the
orientation shown on the
printer cover.
