Auto Pro-Up DBL-STAR STD/MINI, Operating Manual

Page: 12 / 26

12
10.Mounting Rotors
Clean the rotor mounting surfaces before mounting the rotor. Use a wire brush or
sandpaper to clean all mounting surfaces of burrs and rust. The inside diameter of the
center hole must be thoroughly cleaned as well to ensure accurate mounting.
Typical Hubless Rotors Mounting.
a) Mount the most appropriate size of Hole cup, slip the spring into the arbor.
b) Chose centering cone that contact the rotor near the middle of bearing races rather
than near an edge for accurate mounting.
c) Install rotor, then another Hole Cup to hold the rotor
d) Add Spacers as necessary to fill the arbor out to the threaded section.
e) Attach the Silencer Band to the rotor.
Tighten the arbor nut until
the arbor begins to turn
while holding the rotor
Stretch the band
evenly around the
rotor