Auto openers SO-1000F Instruction Manual Download Page 3

To view our how to install video visit:

 

www.autoopeners.com.au

 

  

 
Installation Safety Warnings 

 

This  automatic  garage  door  opener  is  designed  and  tested  to  offer  safe  service  provided  it  is  installed  and 
operated in strict accordance with the following safety warnings. Failure to comply  with the following instructions may 
result in death, serious personal injury or property damage.

 

 

GENERAL WARNINGS 

 

The door may operate unexpectedly, therefore do not allow anything to stay in the path  of the door.

 

 

When operating the manual release while the door is open, the door may fall rapidly due to weak or broken springs or due 
to being improperly balanced.

 

 

Do not disengage the opener to manual operation with children / persons or any objects including motor vehicles within the 
doorway.

 

 

If the door is closing and is unable to re-open when obstructed, discontinue use. Do not use a door with faulty obstruction 
sensing.

 

 

When using auto close mode, a Photo Electric beam must be fitted correctly and tested for operation at regular intervals. 
Extreme caution is recommended when using auto close mode. All safety rules must be followed.

 

 

Due to the risk of entrapment under the door, ensure you test the safety auto reverse function monthly.

 

 

ELECTROCUTION RISKS 

 

Place opener in a protected area so it does not get wet.

 

 

Do not spray with water.

 

 

Disconnect the power cord from mains power before making any repairs or removing  covers. Only experienced service 
personnel should remove covers from the opener.

 

 

If the power supply cord is damaged, it must be replaced by an Auto Openers Service Agent or suitably qualified person.

 

 

Connect the opener to a properly earthed general purpose 240V mains power outlet installed by a qualified electrical 
contractor.

 

 

CAUTIONS 

 

If garage  has  no  pedestrian  entrance  door,  an  emergency  access  device  or  battery backup  should  be  installed.  This 
accessory allows manual operation of the garage door from outside in  case of power failure.

 

 

Practice correct lifting techniques (carton weighs approx. 9kgs).

 

 

Practice correct lifting techniques when required to lift the door as per installation instructions.

 

 

Ensure ladder is the correct type for job.

 

 

Ensure ladder is on flat firm ground that will take the weight without the legs sinking.

 

 

Ensure user has 3 points of contact while on ladder.

 

 

Place a 2 meter exclusion zone around area under the door while it is unsecured.

 

 

Do not move under a door while it is on the door support (or ladder). 

 

Follow the installation instructions. 

 

Fit door support (or ladder) snugly under door before removing bracket. 

 

Ensure door support (or ladder) is on flat ground.

 

 

Examine the door installation, in particular, springs and mountings for signs of wear, damage  and imbalance.

 

 

The garage door must be well balanced. Sticking or binding doors must be repaired by a  qualified garage door installer 

prior to installation of the opener.

 

 

Remove  or  disengage  all  garage  door  locks  and  mechanisms  prior  to  installation  of  the  opener.

 

 

Never plug in and operate opener prior to installation.

 

 

Keep hands and loose clothing clear of door and guides at all times.

 

 

DO  NOT  operate  the  opener  unless  the  garage  door  is  in  full  view  and  free  from  objects  such  as  cars  and 
children/people. Make sure that the door has finished moving before  entering or leaving the garage. 

 

Educate children about garage door safety, keeping transmitters and remote controls of out children

s reach due to 

the potential risk of injury or death. 

 

Summary of Contents for SO-1000F



















Reviews: