16
NexStar Operation
HC-10 NEXSTAR
This section describes the general operation for cranes with the NEXSTAR control system.
Before operating the remote control, read and understand all safety information
in this manual, any manual supplements, and any applicable local, state, or
federal rules and regulations.
Never drive with a load suspended from the crane.
Ensure personnel and objects are clear of the crane path during operation.
Do not move loads over personnel.
General
Radio controlled equipment operates in several directions. Frequently there are other pieces of equipment
and personnel in close proximity. The operator must exercise extreme caution at all times.
Only properly trained operators should operate the radio controlled equipment. This includes knowing and
following all applicable operating and maintenance manuals, safety procedures, regulatory requirements,
and industry standards and codes.
Remote Control Unit
Never mechanically block the switches ON or OFF. When not in use, turn the remote control OFF. Always
store the remote control in a secure space when not in use. Store spare remote controls in a secure space
and only remove after the current remote control has been turned OFF, taken out of the service area,
and secured. Before disposing of batteries, consult local and governmental regulatory requirements for
instructions on proper disposal.
Remote Control Initialization
After powering on the remote control, the LCD display screen turns on and will perform a self-test. During
the self-test, the Nexstar remote control scans for any switches, buttons, triggers that are in the OFF
position. If any switches, buttons, or triggers are on, the “E002 ACTIVITY” failure displays on the display
screen and the remote control powers down.
After a successful self-test, the Nexstar remote control will enter the Normal Operating Mode.
Pre-Operation Test
Before operating the crane, or when a new operator takes control of the equipment, operators should
perform the following checks of the equipment before making a lift:
- Test all warning devices.
- Test all functions.
- Test the remote control E-Stop function.
!
WARNING
!
WARNING
!
WARNING