11
SYSTEM SETTINGS
Motion sensor sensitivity adjustment
The motion sensor of the immobilizer provides five
sensitivity levels (sensitivity increases from 1 to 5, by
default level 5 is activated). To change the sensitivity
level, follow these instructions:
1. Switch the ignition ON without starting the engine.
2. Enter the current PIN-code to authorize. There will
be two indication signals.
3. Enter the immobilizer setup menu (the setup menu
is available within two minutes after the PIN-code
entering). For this purpose press the service/valet
button and hold it pressed during 10 seconds. The
LED or buzzer will start providing indication signals
once in a second.
4. Press the service/valet button twice to enter the
sensitivity control sub-menu. The indication LED
or buzzer will provide a number of signals, which
corresponds to the value of the current sensitivity
level (from 1 to 5). After that the immobilizer will
start providing series of double indication signals.
5. Set new sensitivity level by pressing the button the
required number of times from 1 to 5. The value «1»
corresponds to the switched off sensor, the value of
«2» – to the lowest sensitivity level (response only to
a strong speedup), the value of «5» – to the highest
sensitivity level (response to a slight acceleration).
Each button press will be confirmed by a single
indication signal of the LED or the buzzer. The new
saved value of sensitivity level will be confirmed in
Summary of Contents for Kvant 231
