KINGSLEY–BATE
Fine Garden Furniture
0
ASSEMBLY INSTRUCTIONS FOR THE NT-18
BACK
SEAT
STEP-I
Unpack, inspect and lay the p arts on a clean,
flat, soft surface to avoid marring the wood.
NOTE: During assem bly of the furniture
please match joints with the corresponding
letters or numbers.
RIGHT END FRAME LEFT END FRAME
* NOTE:
A TENON
B MORTISE HOLE
STEP-II
Fit the BACK STRETCHER, BACK LEG
STRETCHER, FRONT LEG STRETCHER and
SEAT into the RIGHT END FRAME mortise holes.
If necessary, gently rock the PARTS while pushing the tenons into the mortise holes until all
joints fit snugly together. Make sure that the numbered tenons correspond with the numbered
mortise holes.
STEP-III
Carefully fit the remaining LEFT
END FRAME mortise holes over
all exposed tenons. If necessary
you may use a rubber m allet or a
regular hammer with the sanding
block between the hammer and
the wood, gently drive all the
mortise holes onto the tenons until joints f it snugly together. Holding the END FRAMES
tight against the component parts, carefully
lift
the chair and place it upright on the ground.
Slide BACK FRAME into position using the exposed dowels in the SEAT as a guide.
1
STEP-IV
Using a proper screw driver,
insert and secure all knock down
bolts as shown on the assembly
photographs.
