28
Figure 6.4
8.
From
System
screen, use
UP/DOWN
scroll button to select the
detecting system (Figure 6.5), and press
OK
button. Wait for
the
Function
screen to appear.
Figure 6.5
If the scan tool fails to communicate with the vehicle’s ECU
(Engine Control Unit), a “LINK ERROR” message shows up
on the display.
Verify that the ignition is ON.
Check if the scan tool’s OBD II connector is securely
connected to the vehicle’s DLC.
Verify that the module is supported.
Turn the ignition off and wait for about 10 seconds. Turn the
ignition back to on and repeat the procedure from step 5.
If the “LINK ERROR” message does not go away, then there
might be problems for the scan tool to communicate with the
vehicle. Contact your local distributor or the manufacturer’s
customer service department for assistance.
9.
Select
Read Codes
from the
Function
menu, and press
OK
button.
System
1. 01-Engine
2. 02-Auto Trans
3. 03-ABS Brakes
4. 04-Steering Angle
5. 05-Acc/Start Auth.
6. 06-Seat Mem. Pass
7. 07-Control Head
8. 08-Auto HVAC
Summary of Contents for MaxiService MST505
Page 78: ...58 ...
