17
18
Main Menu
1) VW/AUDI
2) OBDII/EOBD
3) Oil Reset
4) System Setup
OBDII/EOBD Diag.
1) Read Codes
2) Erase Codes
Erase Codes
Erase Trouble Codes!
Are you sure?
<YES> NO
3.3 Oil Reset
4) If you do wish to proceed to erase the codes, then press teh
Y
button.
5) If the codes are cleared successfully, an
ERASE DONE!
confirmation will show on the displ ay. Pres s any button to return
to previous menus.
6) If the codes are not cleared, then an
ERASE FAILURE!
message will appear. Press the
N
button to return to previous
menus.
1) Turn the ignition off.
2) Locate the vehicle,s 16-pin Data Link Connector (DLC).
3) Plug into the scan tool cable connector to the vehicle,s DLC.
4) Turn the ignition on. But do not start the engine.
6) Use the
UP/DOWN
scroll buttons to select
Oil Reset
from the
menu. Press the
Y
button to accept the option and to move to the
next screen.
5) Press the
Y
button. The
Main Menu
will be observed on the
display.
7) Do the following to select menu options:
a) Use the
UP/DOWN
scroll buttons to mov e the c urso r( ) and
select an optian, then
b) Press the
Y
button to accept the option and to move to the next
screen.
c) Repeat a) and b) to select the necessary options.
If the retrieved DTCs contain any manufacturer specific or
enhanced codes, you will be prompted to refer to the CD DTC
library or the vehicle service manual to view the DTC
definitions.
If the scan tool is not connected or no communication is
established with the vehicle yet, then refer to
Reading Codes
from 1 to 8 at Paragraph 3.2.
Erasing Codes
10) If more than one DTC is found, use the
UP/DOWN
scroll buttons,
as necessary, until all the codes have been shown up.
1) If you decide to erase the DTCs, use the
UP/DOWN
scroll
buttons to select
Erase Codes
from the
OBDII/EOBD Diag,
menu
and press the
Y
button.
2) A warning message comes up asking for your confirmation.
3) If you do not want to proceed with erasing the codes, press the
N
button to exit. A message of
command cancelled
will show up.
