54
maximum value.
6. Tap the
ON/OFF
button on the right side of the Buzzer Alarm
button to turn it on or off.
7. Tap
Done
to save the setting and return to the Live Data screen; or
tap
Cancel
to exit without saving.
If the threshold limits are successfully set, two horizontal lines will appear on
each of the data graphs (when Waveform Graph Mode is applied) to
indicate the alarming point. The threshold lines are shown in different colors
from the waveform of the parameters for distinction.
Record Button
– displays the configuration screen for Record Setting,
on which you can set the trigger type, duration and trigger point for the
data recording function.
a)
Trigger Type
– sets the trigger mode for data recording, mainly of
two kinds: Manual and Auto. There are four options available:
1)
Manual
– allows you to manually start and stop data recording
2)
DTC
– auto triggers data recording when any DTC is detected
3)
DTC Check Mode
– auto triggers data recording when certain
pre-selected DTC types are detected
4)
Parameter
– auto triggers data recording when any parameter
value reaches the preset threshold
b)
Duration
– sets the recording time (for Auto trigger mode only)
c)
Trigger Point
– reserves a relative percentage of a record length
before the data recording start point for reference (for Auto trigger
mode only)
To perform setting for live data record
1. Tap the
Setting
functional button at the bottom of the Live Data
screen.
2. Tap the
Record
navigation button.
3. Tap the
button on the right of
Trigger Type
bar and select the
required trigger mode.
4. Tap the
button on the right of
Duration
bar and select a length
of time.
5. Tap the
button on the right of
Trigger Point
bar and select a
