40
IMPORTANT
•
The upgrade takes about 15 minutes. Don’t turn off
EVO
or the remote
control, or remove your SD card from the camera during the process.
Do not start the motors.
• After upgrading, the remote control may be disconnected from the
aircraft. If you need to pair them again, see
Section 3.2.4: Aircraft &
Remote Control Preparation ( 28 )
.
5.2 Troubleshooting Tips
Q1. If EVO indicates a failure during self-check (Rear LED Indicators will
turn solid red):
• Hardware problems detected, contact the Customer Service:
•
www.autelrobotics.com/contact-us/
Q2. If the motors fail to start up:
• Verify the remote control and the aircraft are paired
• Check the remote control to make sure it’s calibrated correctly
• Verify the aircraft battery level
• Make sure the compass is calibrated correctly
• Make sure GPS is available (if
Novice Mode
is active)
Q3. If takeoff fails after starting motors:
• Double-check that
EVO
is not in a known no-fly zone
•
Make sure the aircraft is on a flat, level surface
Q4. If flight time is preemptively reduced:
•
The most common cause of reduced flight time is a low temperature in the
operating environment or increased takeoff weight
Q5. If EVO does not respond to the remote control during the pairing
process:
• Make sure there are no metal objects, mobile devices or other remote controls
nearby
Q6. If Video Link fails or disconnects frequently:
• Double-check that both
EVO
and the remote control are free from sources of
magnetic or signal interference
Q7. If the camera is powered off during while recording video:
