Autel Robotics EVO II Pro Enterprise, User Manual

Page: 38 / 64

38
Remark

Do not use communication equipment of other frequency bands at the same time, otherwise
the remote controller signal may be interfered.

In actual operation, Autel Explorer prompts when the image transmission signal is poor,
please adjust the position of the antenna according to the prompt, and ensure that the When
controlling the aircraft, it is necessary to timely adjust the aircraft is in the optimum
communication range.

Frequency pairing
When purchased as a set, the remote controller and the aircraft have been in frequency pairing at
the factory, and can be used directly after activated.
In other situations, frequency pairing is carried out using the following methods.
1. Short-press the frequency pairing button next to the USB interface on the right side of the
aircraft body to make the aircraft enter into the frequency pairing state;
2. Turn on the remote control and run Autel Explorer, enter the task flight interface, click the gear
icon in the upper right corner, enter the setting menu, click "Remote Controller -> Digital and
Image Transmission Frequency Pairing> Start Frequency Pairing", and wait a few seconds until
frequency pairing succeeds.

Remote controller calibration
If the rocker is abnormal, the remote controller is recommended to be calibrated. You can calibrate
the remote controller by using Autel Explore App, or calibrated by the following steps.
1. Turn on the remote controller. Enter the App camera interface>set (
)>remote
controller>remote controller calibration. Two branched shapes and two horizontal bars show up on
the screen, representing the left and right rockers and the left and right thumbwheels respectively.
2. Rocker calibration: rush and hold the rockers in eight directions one by one until you hear a
beep.
3. Thumbwheel calibration: rotate the thumbwheel clockwise until you hear a beep. Then rotate
the thumbwheel counterclockwise until you hear a beep.

Rocker mode
This aircraft includes three rocker modes: Japanese manipulator, American manipulator and
Chinese manipulator and. You can set the rocker mode in the Autel Explorer based on your own
preference. The default manipulation mode of the remote controller is "American manipulator". At
the moment, the left rocker controls the elevation and direction of the flight, and the right rocker
controls the forward, backward, and leftward and rightward flight directions of the aircraft.