1 In
trodu
ction
- 4 -
LIMM&SA0-00.fm
Radio transmission of a “Master/Master” system uses two different addresses:
- one is used for the transmitting unit UTX-M, and can be decoded by both receiving units
- one is used for the transmitting unit UTX-S, and can be decoded by both receiving units
1.3
Conformity
Each Modular series radio remote control is in conformity with FCC Rules (Part 90 for
the transmitting unit and Part 15 for the receiving unit).
Operation is subject to the following two conditions:
1) this device may not cause harmful interference and
2) this device must accept any interference received, including interference that may
cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are de-
signed to provide reasonable protection against harmful interference in a resi-
dential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encour-
aged to try to correct the interference by one or more of the following measures:
- reorient or relocate the receiving antenna
- increase the separation between the equipment and receiver
- connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Permitted uses Permitted applications are hoisting machines (construction cranes, bridge cranes,
machines for material handling in general,…).
Forbidden uses
Forbidden applications are:
- machines installed in areas where equipment with explosion-proof characteristics
is required
- machines for moving, raising and transporting people.
Autec cannot be held responsible if the radio remote control is installed on appli-
cations that are different from those permitted.
Working
conditions
To guarantee correct radio remote control operation, all current regulations regarding safety at
work and accident prevention should be respected. All applicable standards and regulations valid
in the user country regarding the use of both the machine and the radio remote control must
always be respected.
Autec cannot be held responsible if the radio remote control is used in unlawful work-
ing conditions.
System must be installed by a licensed technician and in accordance with all rel-
evant local, state/provincial and federal regulations, including but not limited to
NEC, OSHA, CE; etc.
UTX-M
URX-_
URX-_
UTX-S
UTX-M
URX-1
URX-2
UTX-S
URX-1
URX-2
Single mode
Tandem mode
Tandem mode
