Bringing people together
neos
Functioning_EN
calling and conversation
When a call is received from the entrance panel, the monitor starts ringing for a maximum of 30 seconds. As standard,
it performs 4 rings with intervals of 4 seconds between each of them.
During the call period the image appears on the screen, the user can open directly, pressing the button
, or establish
a conversation, in "handsfree mode", pressing the button
, or in "private mode" just picking up the handset
.
The conversation has a maximum of 90 seconds. If you want to continue with the conversation, activate the keypad
and press the button
keypad activation at standby
IN STANDBY, to prevent unwanted presses, the monitor incorporates a security system in which the touch keyboard
remains locked until the push button
is pressed.
self-starting
Activating the keypad and by pressings the button
the user can establish communication with the PANEL / CCTV
CAMERA that he wishes in the case of more than one is present in the installation.
With each press
the system will automatically switch to the next device, showing the image and allowing the
opening of it by pressing the button
dual audio function
At any time the user can alternate between the "hands-free" mode and the "private" mode, indefinitely, during the
duration of the conversation.
If the monitor is in "hands-free" mode, you just have to pick up the handset
and the system will go into "private"
mode automatically.
If the monitor is in "private" mode, all you have to do is press the button
and the system will go into "hands-free"
mode. Afterwards, the user can hang up the headset without losing communication.
calling to concierge
If the monitor is in standby, activating the keypad and by pressing the button
, a call will be made to the concierge
unit. If the system does not have a concierge unit installed, the monitor will emit an error beep.
image adjustment
The monitor allows adjustment of brightness, colour and contrast levels. When the image appears on the screen, you
must press the button
. Each press alternates between the 3 available settings.
To adjust the desired value press the push buttons
external functions
The monitor has 1 push-button
that allow auxiliary functions, such as garage doors, lights, irrigation, etc ...
To do this, an Auta auxiliary relay must be connected to the control circuit we want to control.
privacy function
The monitor incorporates a privacy mode in which the ringing tones are muted for a selected time. If the privacy mode
is active, the monitor shows by flashes the selected period of time (1 flash -
2 hours
, 2 flashes -
4 hours
, 3 flashes -
6 hours,
4 flashes -
8 hours
). After the selected period of time finished, the monitor automatically returns to standard
mode. To enable the privacy mode activate the keypad and press the button
for 4 seconds (
start to blink), select
the desired period of time by pressing the button
. Each press will activate a different period of time between the 3
available ones. Validate the selection by pressing the button
ding dong function
The monitor allows to replace the interior bell of the house, this integrates the two calls (outside panel and house bell)
in a single device. These calls will be differentiated with different melodies and flashes automatically. In order to have
this function, you only have to connect the button of the house bell to the monitor.
cctv surveillance function
The monitor allows the control of panels and CCTV cameras automatically. We activate the keypad and then press the
button
. Each press on the button will activate a different device. To do this, each CCTV camera must be installed
with an Auta digital interface.
melody selection and adjust of the calling volume
If the monitor is in standby, activate the keypad and press
. With each press will select a different melody and a
different calling volume.
There is 4 call melodies and 2 volume levels for each one (MEDIUM and HIGH)
