1
CONTENTS
BASIC COMPACT LAYOUT
Typical Control Settings
Typical Control Settings
20
Use low voltage selection and low
wire speed for light and thin
materials.
Increase voltage and wire speed
as material thickness increases.
MACHINE MAINTENANCE
DO NOT OPERATE THE WELDER WITH
THE SIDE PANELS REMOVED.
Grinding Dust is the greatest enemy of any machine
and the frequency for cleaning your machine is
dependant on the environment you are working in.
After disconnecting the machine from its power source,
remove the side panels, and with compressed air remove
any dust from the transformer windings, diode pack, fans
and switches etc.
Other Key components to inspect are :
Spool Post ~
Check for Tension / smooth operation
Grease periodically
Earth Lead ~
Broken / frayed cabling
Damaged / burnt clamp
Torch ~
Damaged lead
Worn tip / Diffuser / Tip holder / Nozzle
Do not touch components or wiring
while panels are removed.
Drive System ~ Tension (Average setting 3)
Drive rollers - check for wear
Guide tube alignment / wear
*
DO NOT LUBRICATE*
