AUSA D 201 RH, Operator'S Manual

Page: 52 / 80

D201RH / RHS / RHG / RHGS
50
Periodic
Maintenance
Operations
(fi
g.
1)
c
(fi
g.
2)
c
(fi
g.
3)
a
b
Draining (fig. 1)
- Remove the wheel.
WARNING
If is necessary to remove the drain plug while the oil is still hot, place it on the
upper part of the wheel hub, and remove the plug carefully covering it with a
piece of cloth or similar.
- To drain the oil, turn the wheel reduction hub until plug (c) is located on the lower
part of the wheel hub.
Topping up (fig. 2)
- Turn the wheel until the hub reduction plug (c) is in a horizontal position .
- Fill with the specified oil through the plug (c) . See the Table of LIQUIDS AND
LUBRICANTS (references and capacities) in this Manual for oil type and
capacity.
Dispose of used oil in authorized waste disposal centres.

Hydraulic circuit (fig. 3)
Checking the level
The verification must be done with the dumper on horizontal ground, the bucket in the
lowest position, the self-loading shovel in rest position and is the engine stopped.
Note:
The oil tank is equipped with an oil level indicator (b) . During regular services, ensure
that the oil level does not fall below the level of the indicator. If this occurs, add oil
immediately to avoid damage to the hydraulic pumps then investigate the cause of the
drop in level (i.e. leaks).
- Ensure that the oil level is visible through the indicator (b) .
- If necessary, add oil to the tank by removing the cap (a) .