Aurora AU 4308, Manual

Page: 9 / 12

AU
4308 ENG
9
Personal Scale
Electronic
Before using the unit read these instructions
carefully.
Place the scales on the flat, dry and slip proof
surface.
In order to avoid inaccuracy while weighing, do
not use the scales on carpets and carpeted floor.
To get maximally precise results while weighing
put the scales each time on the same place.
Do not stand on the scales with wet feet or on
the wet surface of the scales. You may slip down
and get injured.
Be careful while standing on the scales: firstly put
your one foot on the scales, make sure that the
scales are stable and then put the other foot on
the scales.
Stand on the scales and distribute your body
weight evenly. Stay steel while weighing, do not
jump on the surface of the scales.
Use the scales away from heating devices.
Do not use and do not keep the scales in rooms
with high humidity (more than 80%), protect the
body of the scales from water or other liquids, it
may influence the precision of weighing and lead
to outrage.
Be especially careful if the unit is used by children
or disabled persons.
Do not allow children to use the unit as a toy.
Do not expose the scale impact.
If you are not going to use the scales for a long
time, you should take the batteries out of the bat-
tery compartment.
While inserting batteries, strictly follow the polar-
ity according to the marks.
Replace the batteries in time.
Do not dismantle and do not repair the scales
yourself. If there are any damages in the unit, ap-
ply to the authorized service center.
The unit is intended for household usage only
and is not intended for medical or commercial
usage.
If the product for some time exposed to tempera-
tures below 0 º C, before turning it should be kept
under ambient.
SAFETY PRECAUTIONS
The package includes a battery 3V lithium bat-
tery (CR2032).
Before operating, remove the insulation film out
of battery contact.
Replacing the battery
Variant number 1. Open the cover of the battery
compartment (located in the lower part of the
body). Remove the used battery with a sharp ob-
ject, as shown in the figure. Install a new battery,
get under one side of the battery compartment
bulkhead. When installing the battery, note the
polarity.
THE BATTERY