Aurora AU 3080, Manual

Page: 9 / 12

AU
3080
Hair clipper set
ENG
9
Carefully read the instruction manual.
Use the product only for its intended purpose, as
described in the instructions.
Before switching on, check that the product spec­
ifications listed on the label, the voltage supply.
Use only for domestic purposes under these op­
erating instructions. The product is not designed
for industrial or commercial use.
Do not use outdoors.
Always unplug the product from the mains be­
fore cleaning or when not in use.
To avoid electric shock, do not immerse the prod­
uct in water or other liquids.
If this happens,
DO NOT TOUCH THE APPLIANCE , unplug
it from the wall outlet and contact a service cen­
ter for inspection.
Do not use this product in close proximity to the
bath, shower or swimming pool.
Do not operate the product in areas where aero­
sol spray and used flammable liquids.
The product is not intended for use by persons
(including children) with reduced physical, sen­
sory or mental capabilities, or if they have no life
experience or knowledge, unless they are con­
trolled or not instructed on the use of the prod­
uct by a person responsible for their safety.
Children must be controlled to prevent the game
with the product.
Do not leave the product unattended.
Do not use accessories not included with this
product.
Do not carry the product by the power cord or a
loop for hanging.
Do not use a damaged power cord and / or plug.
To avoid danger, the cord is damaged, it should
be replaced by an authorized service center.
Do not attempt to repair the product or replace
any parts. When problems are detected, please
contact your nearest service center.
Keep the cord away from sharp edges and hot
surfaces.
If the product was some time at temperatures
below 0ºC, before switching it should be kept in­
doors for at least 2 hours.
ATTENTION!
Regularly lubricate the blade.
Not recommended for the lubrication of the
blades hair oils, fats and oils of vegetable origin,
oils diluted with kerosene or other solvents.
To avoid overheating, do not use the product lon­
ger than 10 minutes, and be sure to take a break
for at least 10 minutes.
Do not use the machine for inflammation of the
skin.
Do not cut machine animals.
Do not allow the slots in the product debris and
any fluids.
Nowhere do not place the machine where it
works, because it may result in injury or property
damage.
Do not use the machine with damaged scallops
or one of the teeth ­ this can lead to injury.
SAFETY PRECAUTIONS
GETTING STARTED
Unpack the product and remove any packing
material.
Carefully wipe with a soft damp cloth body and
all the accessories.
GREASE BLADES
To ensure reliable and continuous operation clip­
pers, blades should be regularly lubricated after
each haircut.
To lubricate the blades using oil, which is supplied.
Lubricate the blade with oil (Fig. 8). Turn the clip­
per so that the oil is uniformly distributed be­
tween the blades, check the uniformity of their
course. Then turn off the product and unplug it.
Remove excess oil with a dry cloth.
Not recommended for the lubrication of the
blades hair oils, fats and oils of vegetable origin,
oils diluted with kerosene or other solvents.