15
GB/IE/NI
Mounting the temperature station
and / or the outdoor sensor on a wall:
Note:
You will require an electric drill and a
crosshead screwdriver for this step.
CAUTION! DANGER TO LIFE, RISK
OF INJURY AND MATERIAL DAMAGE!
Read the operating and safety instructions for
your drill carefully.
DANGER TO LIFE!
Take care that you do not hit electricity, gas
or water lines when you drill into the wall. If
necessary, check with a pipe and cable de-
tector before drilling.
Temperature station
Note:
Before mounting the temperature sta-
tion, please remove the stand
26
by simply
pulling it off.
Mark the position of the hole (ø approx.
7.7 mm) on the wall.
Drill the hole with an electric drill.
Insert the dowel
28
into the drilled hole.
Using a crosshead screwdriver, screw the
screw
27
into the dowel.
Hang the temperature station by placing
the hanger
22
on the screw.
Outdoor sensor
Mark the position of the hole (ø approx.
7.7 mm) on the wall.
Drill the hole with an electric drill.
Insert the dowel
33
into the drilled hole.
