34
Set1
Set2
Output
Alarms
Digit
OK
Max/Min
Reset
Offset adjustment
After you have calibrated your meter, you can use the
OF.ST
feature to make fine additions
or subtractions to the reading, without affecting the calibration itself.
Lockout Switch must be OFF
Press 3 seconds
Set1
Set2
Output
Alarms
Digit
OK
Max/Min
Reset
Press repeatedly until you see
OF.St
, followed by the existing offset
value.
(Default is
0.000
)
1
2
3
4
Set1
Set2
Output
Alarms
Digit
OK
Max/Min
Reset
Use DIGIT button to select each digit
in turn, UP or DOWN buttons to
increase or decrease each digit’s
value. If you want to set a negative
value, use DIGIT to select the left
hand digit, and press the down button
to go below 0 to activate the - sign.
Press OK when done.
Set1
Set2
Output
Alarms
Digit
OK
Max/Min
Reset
Done!
!! This feature is available in Advanced Mode only !!
You may want to adjust a SCALE FACTOR value also, without affecting calibration. See
the separate SCALE page for this feature.
Press to accept
OFF
Circuit board ON
