AUREL DEMO XTR-8LR10, User Manual

Page: 13 / 17

DEMO XTR-8LR100
DEMO XTR-8LR10
User Manual
Le caratteristiche tecniche possono subire variazioni senza preavviso. AUR°EL S.p.A. non si assume la responsabilità di danni causati dall’uso improprio del dispositivo.
AUR°EL S.p.A. Via Foro dei Tigli, 4 - 47015 Modigliana (FC) – ITALY
Tel.: +39.0546.941124 Fax: +39.0546.941660
http://www.aurelwireless.com - email: rfcomm@aurel.it
Rev 2.2 17/05/2016
Page
13
of
17
Command from
PC
→
DEMO XTR-
8LR100
Answer from
DEMO XTR-8LR100
→
PC
Description
++++ COMMAND-MODE Command mode enter
ATS10=1 OK It activates network mode
ATS30=1 OK Set the time of cyclic transmission of the
status of ADC to 1sec
ATWR OK
EXIT
It saves the new settings on Eprom and
exits from command mode
Close jumper SET_A and SET_C of unit 1, press and release the reset button on the demo board.
The cycle starts, at intervals of one second, ADC value will be transmitted.
The transmission is signaled by the blink of LD1.
From sleep mode unit 2, send the following commands:
Command from
PC
→
DEMO XTR-
8LR100
Answer from
DEMO XTR-8LR100
→
PC
Description
++++ COMMAND-MODE Command mode enter
ATS10=1 OK It activates network mode
ATWR OK
EXIT
It saves the new settings on Eprom and
exits from command mode.
From sleep mode, close the jumper SET_A and set the speed of the serial port of Realterm to 115200bps.
At intervals of 1 second the unit 2 starts to receive packets structured in the following way:
Below, an example of the message received by a node in "TX ADC cyclical" displayed by Realterm
connected all'unità2: