DEMO RX BOOST 869
---------------------------------------------------------------------------------------------------------------------------------------------------
User manual 650201135G
The technical features can be change without forecast. AUR°EL S.p.A doesn’t assume any responsibilities due from improper use of the device.
---------------------------------------------------------------------------------------------------------------------------------------------------------------------
AUR°EL S.p.A. Via Foro dei Tigli, 4 - 47015 Modigliana (FC) – ITALY
Tel.: +39.0546.941124 Fax: +39.0546.941660
http://www.aurelwireless.com
- email:
08.02.2010
Page 2 of
3
Note: The auto learning procedure of the transmitter with one, two, three and four buttons can be
carried out by each buttons, as the central unit manages the standard bit sequency assigned to
each channel as follow:
Only active S0 = channel 1
Only active S1 = channel 2
Only active S2 = channel 3
Only active S3 = channel 4
From Monostable to Bistable mode.
On the default mode all the four outputs are monostable, but it’s possible switch them in bistable
mode through the follow sequence:
Memorized a transmitter, push for a short moment the auto learning button. At this point the led
starts to blink quickly for ten seconds, before the end of this time push again for other short
moment and you will note that led will switch in a permanent lighting. At this stage you have other
ten seconds to transmit the code of the button to be switched in bistable mode. Led will blink
thrice to show the correct transition to the bistable working. Repeating all the operation on the
same channel the led will blink twice to indicate the return to the monostable working.
NB. The procedure above showed, it can be carried out only if it was memorized a transmitter before. In the
case of memorization of more transmitters this procedure can be activated from all indistinctly. Active it from
one transmitter is valid for all the others.
Erasing memory
To erase the memory of the micro from all matched transmitter, push for an instant the auto
learning button until the led starts to blink. Now pushing again and keeping it for five seconds until
the led switches off itself. At this point verify that the led carries out 5 consecutive blinks to show
the correct erasing of the memory.
N.B. Realizing the erasing of the memory consequently will be erase also the several settings of the channel
previously set.
Mainly features
min
Typical
max
Unit
Dc voltage supply
10
12
15
Volts
AC voltage supply
23
24
26
Volts
Sby current consumption
8mA dc--20mA ac
m ampere
max** current consumption
52mA dc--66mA ac
m ampere
Max current of relay
1A/ 220Volt
Impedance antenna
50Ohm
Frequency
869,5MHz
Receiver sensibility
-111dBm*
Modulation
FSK
