Aureal Inc.
Vcom V90 PCI Modem Installation Guide
iii
This product contains provisions for fax branding. It is up to the end user to ensure that any fax software used with
this modem complies to, and is properly configured for, fax branding.
Statement of Compliance to Canadian Regulations
NOTICE:
The Industry Canada (IC) label identifies Certified Equipment. This certification means that the equipment meets
certain telecommunications network protective, operational, and safety requirements as prescribed in the appropri-
ate Terminal Equipment Technical Requirements documents. The Department does not guarantee the equipment will
operate to the user's satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the
local telecommunications company. The equipment must also be installed using an acceptable method of connec-
tion.
Users should be aware that compliance with the above conditions might not prevent degradation of service in some
situations.
A representative designated by the supplier should coordinate repairs to Certified Equipment. Any repairs or alter-
ations made by the user to this equipment, or equipment malfunctions, may give the telecommunications company
cause to request the user to disconnect the equipment.
Users should ensure, for their own protection, that the electrical ground connections of the power utility, tele-
phone lines, and internal metallic water pipe system, if present, are all connected together. This precaution may be
particularly important in rural areas.
CAUTION:
Users should not attempt to make such connections themselves, but should contact the appropriate electric inspec-
tion authority, or an electrician, as appropriate.
Ringer Equivalent (REN):
The ringer equivalence number (REN) assigned to each terminal device provides an indication of the maximum num-
ber of terminals allowed to be connected to a telephone interface. The termination of an interface may consist of
any combination of devices subject only to the requirement that the sum of the ringer equivalence numbers of all
the devices does not exceed five (5.0).
On the lower left, backside of the PCB is a label that contains, among other information, the FCC registration num-
ber and the ringer equivalence number (REN) for this equipment.
For warranty repair, please see the above section: Warranty.
