8
9
To fasten the
AURATON RTH
receiver to the wall:
1
) Remove protective covers from the lower and upper part of the regulator.
(See chapter: “Fastening the RTH receiver”).
2)
On the wall, mark the location of holes for fastening screws.
3)
In marked places, drill holes of a diameter corresponding to the bundled
wall plugs (5 mm).
4)
Insert wall plugs into the drilled holes.
5)
Screw in the RTH receiver to the wall with screws, making sure they hold the
receiver securely.
Fastening the RTH receiver to the wall
NOTE
: If the wall is wooden, there is no need to use wall plugs. In such a case,
drill two holes 2.7 mm in diameter instead of 5 mm, and screw
the screws directly into the wood.
AURATON RTH
hole for fastening
the receiver to the wall with a screw
NOTE
:
The
RTH
receiver cannot be placed in metal containers
(e.g. an assembly box, a metal enclosure of a heater) in order to not to
interfere with its operation.
hole for fastening
the receiver to the wall with a screw
3
. Connect the heating device to the
control connection terminals
of the
AURATON RTH
receiver.
Proceed in accordance with the service
manual of the heating device. Most
commonly, the
COM
(common) and
NO
(normally open) terminals.
4
. Connect power supply conductors to the
power supply terminals
of the
AURATON
RTH
receiver, observing safety rules.
5
. After connecting the conductors, they must
be secured with the cable tie clamps and
reinstall protective covers of the
AURATON
RTH
receiver.
Fastening the RTH receiver
1
. Take off protective covers from the lower
and upper part of the
AURATON RTH
receiver.
2
. Take off cable tie clamps from the lower
and upper part of the
AURATON RTH
receiver.
protective cover
cable tie clamp
NOTE:
When installing the
AURATON RTH
receiver its power supply must be
disconnected. It is recommended that the
installation is performed by a qualified
specialist.
NOTE:
The permanent electrical system
of a building must include a breaker
and an overcurrent protection.
~
230V AC