AURATON 2025 RTH, User Manual, Page: 10 / 32

10 11
3 . A properly completed deregistering process is signalled by the LED on the
AURATON RTH receiver no longer flashing red and the receiver reverting back
to normal operation.
In the event of an error during the deregistering process, repeat steps 1 and 2.
Should more errors occur, deregister all paired devices (see “RESET - Deregistering
all devices paired with the RTH receiver”) and attempt to pair the device again
.
RESET - Deregistering all devices paired
with the RTH receiver
In order to deregister all devices paired with
the RTH receiver, simultaneously press both
the pairing and the deregistering button
(
and ) and hold them for at least
5 seconds until the LED flashes alternating
red and green. Then release both buttons.
A properly completed process of
deregistering all devices is signalled after
approx. 2 seconds by the LED colour
changing to green and then switching it off
for a short period of time.
.. ..
Signalling operation and reception
of data packet
Each radio transmission received by the AURATON RTH receiver from the paired
device is signalled by a temporary change of LED colour to orange. Switching on
the relay is signalled by the LED lit red, whereas switching it off is signalled by the
LED lit green.
LED
NOTE : If after executing the RESET function the RTH receiver is disconnected
from power supply and then connected again, the receiver will automatically
enter “pairing” mode for 120 seconds. A newly purchased RTH receiver without
any factory-paired devices (i.e. not the one bundled with the regulator) will
behave the same way.
2 . On the AURATON 2025 RTH regulator, press the button and hold it for
5 seconds until the transmission symbol ( ) appears on the display. Release
the button - the regulator transmits the pairing signal for 5 seconds.
PROG
radio
3 . A properly completed pairing process is signalled by the LED on the AURATON
RTH receiver no longer flashing green and the receiver reverting back to normal
operation.
In the event of an error during the pairing process, repeat steps 1 and 2. Should
more errors occur, deregister all devices by executing the RESET function of the RTH
receiver (see “RESET - Deregistering all devices paired with the RTH receiver”)
and attempt to pair the device again.
NOTE: One receiver can have only one temperature regulator assigned.
Pairing the AURATON 2025 RTH wireless
temperature regulator with the RTH receiver
1 . The process of pairing the 2025 RTH regulator with
the RTH receiver is initiated by pressing the left
pairing button (marked with a green triangle - )
on the
RTH receiver and holding it for at least
2 seconds, until the LED starts flashing green,
and then releasing the button.
The AURATON RTH receiver waits for pairing
for 120 seconds. After that time, it automatically
returns back to normal operation.
2 . On the AURATON 2025 RTH regulator, press the button and hold it for
5 seconds until the transmission symbol ( ) appears on the display. Release
the button - the regulator transmits the pairing signal for 5 seconds.
PROG
radio
Deregistering the regulator from the RTH receiver
1 . Deregistering the 2025 RTH regulator from the RTH
receiver is initiated by pressing the right deregistering
button (marked with a red triangle -
) on the
RTH receiver and holding it for at least 2 seconds, until
the LED starts flashing red, and then releasing
the button.
The AURATON RTH receiver waits for deregistering for
120 seconds. After that time, it automatically returns
back to normal operation.
....
NOTE: The AURATON 2025 RTH wireless temperature regulator sold with the
AURATON RTH receiver is already paired. Devices sold separately
require “pairing” .
LED
LED