Rev. A 07/10
AMMF16R
6
A screw driver is needed for assembly.
1. Ensure that the power cord is disconnected from the power outlet.
2. Align misting fan pole to the base hole to the front direction of the base. Gently push the hose and
power cable of the air pump aside and press the mist fan pole until the screw hole is aligned. (fig. 1).
Make sure you do not
kink
the hose in this process.
3. Fasten the misting fan pole assembly to the power base assembly with the two screws (fig.1).
4. Fasten the misting fan pole assembly to the power base assembly with the pole screw (fig.2).
5. Loosen the pole lock knob and pull the inner pole out. Tighten the lock knob and attach the mist fan
assembly to the inner center pole and fasten screw knob (fig. 3).
6. Disassemble the rear misting fan guard nut
(rotate counterclockwise)
and the misting fan blade nut
(rotate clockwise)
from the misting fan head assembly (fig.4).
7. Align the rear fan guard hole to the three pins on the motor housing, and fasten the rear fan guard to
the fan head assembly with the rear fan guard nut (figure 5).
8. Mount the fan blade to the fan motor shaft (fig.6). Make sure the fan blade gap aligns with the pin clip
on the motor shaft and then screw on the blade nut (fig.7). Mount the front guard and tighten all the hinges
around outer rims of the fan guard (figures 8 & 9).
9. Connect nozzle housing by gently sliding the nozzle housing into the holder on the front fan guard
(fig.10)
10. Connect the air and water tubes to the connectors on the misting fan pole assembly. The water is the
smaller tube. Make sure the tube is pushed all the way into the connector, and then make the electrical
connection (fig.11)
General Assembly Instructions
Formatted:
Indent: First line: 0 ch
Deleted:
kinked
Deleted:
¶
