8
Cabling
The I/O ports on the back of the unit are shown as following:
1 Right Balanced Analog Input
8
Left Balanced Analog Input
2 Right #1 Single-Ended Analog Input
9
Right Balanced Analog Output
3 Left #1 Single-Ended Analog Input
10
Right Single-Ended Analog Output
4 Right #2 Single-Ended Analog Input
11
Left Single-Ended Analog Output
5 Left #2 Single-Ended Analog Input
12
Left Balanced Analog Output
6 Right #3 Single-Ended Analog Input
13
AC Mains Power Cord Socket
7 Left #3 Single-Ended Analog Input
Please be sure to power off all units in your system before any cabling job, failed to follow
this instruction may result in permanent damage to the device and void any warranty.
ALWAYS POWER OFF TAURUS PRE BEFORE CABLING!
z
Analog Inputs
The balanced and single-ended analog inputs are individually buffered, however, it is still
strongly recommended to disconnect unused ports to avoid any potential electromagnetic
interference induced by cable.
The gain of RCA and XLR inputs are 16dB and 10dB with a maximum allowed level at
+18dBu and +24dBU. Please be sure to use a source component with its output level
within this range.