8
Cabling
The I/O ports on the rear of the unit are shown as following:
1
Right Balanced Analog Output
8
USB 2.0 High Speed Input
2
Right Single-Ended Analog Output
9
USB DAC Output
3
Left Single-Ended Analog Output
10
USB Storage Input
4
Left Balanced Analog Output
11
Ethernet Connectors
5
AES/EBU Balanced Digital Input
12
WiFi Antenna Connectors
6
Coaxial Digital Input
13
Main Power Switch
7
Toslink Digital Input
14
Main Power Inlet Socket
Please make sure to power off all units in your system before any cabling job, failed to
follow this instruction may result in permanent damage to the device and void any warranty.
ALWAYS POWER OFF ALTAIR BEFORE CABLING!
l
Analog Outputs
The balanced and single-ended analog outputs of ALTAIR are buffered individually.
These two outputs groups can be used simultaneously. However, we suggest you to
disconnect unused ports to avoid any potential electromagnetic interference induced
by cables.
The amplitude of analog outputs is adjustable with maximum level at about 4.4Vrms
on both XLR and 2.2Vrms on RCA outputs. Please pay double attention NOT to short
any pin of any analog output to ground.
Summary of Contents for ALTAIR
Page 23: ...23 ...