AUMA FQM, Operation Instructions Manual, Page: 29 / 36

8. Indications
8.1. Indications on display
The indications described hereafter exclusively apply to the functions of the fail safe
unit. For further indications of actuator controls, refer to the operation instructions
pertaining to the actuator or to the Manual (Operation and setting) pertaining to
actuator controls.
8.1.1. Indications during and after initialisation
Information
Actuator controls cannot be actuated during initialisation.
FQM fail safe ini.
During initialisation, the actuator controls display shows the following message in
status indication
S0001 : FQM fail safe ini.
Figure 23: Example left: Fail safe CLOSE, right: Fail safe OPEN
[1] End position of FQM fail safe unit
FQM (valve) is in end position CLOSED
FQM (valve) is in end position OPEN
[2] A small arrow points into the operational direction of the actuator during initial-
isation.
FQM FS ready
After successful initialisation, actuator and valve are in the same end position. In the
status line (top), the symbol is displayed, i.e. the constant force spring is wound,
the FQM is ready for fail safe operation. At the same time, the display indicates the
actuator position as figure (default setting %). For valve operation, the actuator is
now ready to operate in standard mode.
Figure 24: Example of standard operation
[1] End position of FQM fail safe unit
= FQM fail safe unit (valve) is in end position CLOSED
= FQM fail safe unit (valve) is in end position OPEN
[2]
Actuator position
Bar chart empty = Actuator is in end position CLOSED (0.0 %)
Bar chart black = Actuator is in end position OPEN (100 %)
Information
FQM fail safe ini. and ( FQM FS ready ) indications can be supplied as signals via
digital outputs.
➭
page 31, Signals (output signals)
8.1.2. Indications during fail safe operation
Information
Actuator controls cannot be actuated during fail safe operation.
29
FQM 05.1 – FQM 12.1 / FQMEx 05.1 – FQMEx 12.1
Indications