INSTALLATION AND WIRING INSTRUCTIONS
Fig A.
Remove ceiling tile and
drill 5/8” (16mm) hole in the
desired location.
Fig D.
Install the threaded nut with
shoulder side down and secure.
Fig G.
Fasten the lid
3
on top of the
junction box. Insert RJ45/Cat cable
into JBM3 receptacle. (See back page
for installing seismic cable)
Fig J.
Position the microphone by
turning the cable as necessary
and gently turn the nut clockwise to
secure (1 to 2 turns). Do not
over tighten.
Fig B.
Position the JBM3 plenum rated
junction box
2
over the drilled hole.
Fig E.
Insert the 7 pin mini female XLR
connector into the male receptacle.
Fig H.
If using Audix Cat 7 LSOH
interface cable
8
, screw on the
brass bell housing over the RJ45
connection and reset ceiling tile.
Fig K.
Microphone elements are
spaced 120 degree apart. Channel 1
is directly below the Audix logo.
Fig C.
Remove the nut from the
threaded portion of the M3 cable
1
,
feed cable through the tile hole and
into the junction box.
Fig F.
Set the initial height of the M3
and spool the excess cable inside
the junction box.
Fig I.
Adjust the cable to exact
desired length by either feeding
or pulling the cable through the
ceiling mount.
Fig L.
Connect RJ45 cables into
the breakout cable and connect
to DSP Controller.
