Audison Prima AP5.9 bit, User Manual

Page: 42 / 59

USER’S MANUAL
42
AP5.9 bit /
This window is enabled. You can click directly on the speaker or speaker
system to be able to display or set the parameters for the individual
channel. Once selected, the speaker(s) will be highlighted.
If you hold down the CTRL key and click on another channel, it will also
be selected and highlighted as occurs with the "Channel Map"
(see sec. 7.3.8)
. Listening point visual indicator.
This window includes the position indicator (in red).
There are four preset points: driver, passenger, front center and rear
center for passengers.
The indication only acts as a reference, allowing you to display the
listening points for which the digital display calculation was optimized
(see sec. 7.3.11)
. If you set the delays in relation to the "driver" position and
then you wish to also optimize the system for the "passenger" position,
you must reset the distances in the specific menu since the system
does not update them automatically.
If used together with the presets
(see sec. 7.3.14)
it is useful to try different
setups according to the different listening points.
AP5.9 bit manages nine crossover filters, one for each output channel.
Each filter allows you to set the parameters of a single output channel.
1. Xover L/R Link: Lets you transfer the adjustments made on the Right
channel to the Left one and vice versa. To activate it, you must click
on the blue light, which will come on. Xover L/R Link acts on all of the
adjustments of the Filter Settings except for Set Distance (Delay) .
2. Invert Phase: Inverts the phase of the channel under examination
by 180°. This can be done by selecting the green light which will turn
on. This can be useful to solve phase alignment problems among
the different filtered channels.
3. Filter Type:
Lets you select the type of filter to assign
to the channels:
- Full Range
- Low Pass
- High Pass
- Band Pass
7.3.9 SELECT CHANNEL
7.3.10 FILTER SETTINGS
9
10
To act on another channel without losing the selection, simply click to the right of the desired channel in the EDIT
column. The CHANNEL MAP window also lets you mute the individual channels by clicking on MUTE to the left of
the desired channel.
If MUTE is active on the channel, "m" is shown in red.
If the SOLO function is active, "s" is shown in green.
If there are time delays on the channel, "fds" is shown in yellow. A channel can also be selected as shown in the
outline in the image
(see sec. 7.3.9)
.
7
If you wish to check the electrical response of the Rear system together with
the Subwoofer, you must clear the Front system selection. However, the
software will only let you operate on a single channel and will show the
message “EDIT” in red to the side of the channel that you can operate on.
More specifically, the graph will show the electrical responses from the only
crossover related to the channel being edited in red. The overall electrical
response from all channels selected will be shown in yellow, taking into account
the crossover filters and equalizations. The final result will be shown in green.