Note
If the changer is to be installed in a car that is equipped with an on-board drive or navigation computer, do not disconnect
the battery cable. If the cable is disconnected, the computer memory may be lost. Under these conditions, use extra
caution during installation, to prevent a short circuit.
Do not install the unit in the following locations.
l
Locations exposed to direct sunlight.
l
Where hot air is discharged from the car heater.
l
In areas subject to extreme temperatures.
Incorrect installation can cause the sound to "skip" when playing a disc.
Mount the unit firmly in place, using the supplied brackets and screws.
Be careful not to damage the car wiring.
l
Be sure to use the supplied screws.
l
Be careful not to snag any wires when tightening screws.
l
Do not use any of the screws that are part of the brake or steering system, to install the unit.
l
This unit cannot be installed on either side or up-side down. Installation in such positions will cause the mechanism
to malfunction.
Installation and Wiring Precautions
3
To prevent a short-circuit,
l
Be sure to turn off the ignition and remove the negative (-) battery cable, prior to installation.
l
Connect power wires last.
1
BEFORE INSTALLING THE UNIT
Transport Lock Screws
The mechanism in the CD changer is "locked" into place during shipment by the
transport screws. Be sure to remove the screws prior to installation.
l
Caution
l
After removing the transport lock screws, place a piece of masking tape over
each screw hole. The tape will keep out dust , which could cause the unit
to malfunction.
6
5
4
3
2
TRANSIT BOLTS
(2 RIGHT SIDE, 1 LEFT SIDE)
