Page 2
PREPARATION FOR SYSTEM PROGRAMMING:
1. CONNECTING COMPONENTS:
CAUTION: THE SECURITY HARNESS MUST HAVE ALL VEHICLE CONNECTIONS INSTALLED
PROPERLY AND ALL SECURITY COMPONENTS CONNECTED BEFORE CONNECTING THE VEHICLE’S
BATTERY . FAILURE TO COMPLY WITH THIS CAUTION COULD RESULT IN SYSTEM FAILURE AND
OR FAILURE TO PROGRAM PROPERLY.
THE SECURITY SYSTEM WILL GO INTO THE
ALARM MODE WHEN THE BATTERY IS
CONNECTED. PRESS THE UNLOCK BUTTON ON
THE REMOTE TRANSMITTER TO DISARM THE
SYSTEM.
IMPORTANT: PLEASE BE SURE TO READ AND BECOME FAMILIAR WITH THE PROGRAMMING INSTRUCTIONS
BEFORE YOU ACTUALLY PROGRAM THE SYSTEM.
STEP 1
E
START WITH VALET SWITCH OFF
STEP 2
TURN IGNITION KEY TO ON
CHANNEL 1
" LOCK "
MEMORY
POSITION
# 1
MEMORY
POSITION
# 2
MEMORY
POSITION
# 3
MEMORY
POSITION
# 4
Now press the LOCK button ( hold the button for 3 seconds until the horn sounds ) on all transmitters
that you want to program ( up to 4 ), or continue on to the next step. Remember, when you're
programming more than one transmitter, press the lock button on the first transmitter until the horn
sounds, then press the lock button on the second transmitter, etc.
Never activate two or more
transmitters at the same time while in programming mode.
STEP 3
E E
E E
VALET SWITCH ON
THEN OFF 3 TIMES
1 BEEP
HORN SOUNDS
E E
PROGRAMMING NEW or REPLACEMENT
TRANSMITTERS TO THE SE MODULE:
IMPORTANT NOTE : Once you enter the programming mode, if 15 seconds elapse with no activity on
the system, the programming mode will be terminated. This is indicated by one soft chirp immediately
followed by one loud chirp. If this happens, simply start over.
The SE System should be disarmed before beginning ! You can disarm by either pressing the unlock
button on a transmitter that is already programmed, or by using the valet switch.
