128-8794
10 of 24
Page 10
To change or adjust the shock sensor, press and release the ARM button of your
keychain transmitter.
1. Within 2 seconds of arming, press and release the ARM button 1 time to
defeat the pre-detect stage of the shock sensor. (The lights will flash and the
siren will chirp once.)
2. Within 2 seconds of step 1, press and release the ARM button 2 times to
defeat the pre and full detect stages of the shock sensor. (The lights will
flash and the siren will chirp twice.)
3. Within 2 seconds of step 1, press and release the ARM button 3 times to
enter the "City Mode" of operation. (The lights will flash and the siren will chirp
three times.)
While under control of the remote start, the system can be programmed to allow
you to shunt the shock sensor from the transmitter. If the system has been so
programmed, simply press the lock button of your keychain transmitter anytime
during the remote start cycle. The shock sensor will be shunted for the entire run
cycle and will resume normal operation after the remote start unit shuts off.
Check with your installation center to determine if this feature has been
programmed into your system.
Push-Button LED Receiver Safety Control Switch
The Push-Button LED control switch located in the receiver allows you to
temporarily disable the remote starting function of the system. This recommended
whenever the vehicle is being serviced. To place the system in the service mode:
1. With the system disarmed/unlocked, and the ignition switch off, Press and
Hold the Push-Button, found on the windshield receiver, in.
2. Turn the ignition switch on, off, on, off, on, off.
3. The LED begins to flash two short flashes followed by one long flash and
continues this pattern until returned to normal mode of operation.
This puts the unit into the Remote Start Override mode indicating that the
remote start is in the service mode and will not start from RF or any other input
Posse or otherwise.
To Exit Remote Start Override Mode
1. With the system disarmed, Press and Hold the Push-Button, found on the
windshield receiver, in.
2. Turn the ignition switch on, off, on, off, on, off.
3. The LED turns off indicating that the Remote Start unit is fully functional once
again.
REMOTE STARTING THE VEHICLE
The system WILL NOT start the vehicle if any one of the following conditions
exists:
1. The Vehicle Hood Is Opened.
2. The Gear Selector Is In Any Gear Other Then Park.
3. The Brake Is Depressed.
4. The Safety Control Switch Is In The Off Position.
WARNING!
Be certain that the vehicle is outdoors before using this or any remote
vehicle starting device. A running engine produces dangerous carbon
monoxide fumes which can be harmful or fatal if prolonged exposure
occurs. DO NOT remote start the vehicle if it is garaged.
To Remote Start The Vehicle:
Press and release the programmed channel of your keychain transmitter two
times within 2 seconds. The vehicle will start and remain running for the
pre-programmed 5, 10, 15, or 20 minutes. As a visual indication, the parking
