background image

128-6121

1 of 4

TRANSMITTER PROGRAMMING GUIDE

Model : PRO-OE3B3

The transmitters included with the security system have been pre-programmed
at the factory, with each button pre-assigned to control a specific function of the
security system. Although the security system in the vehicle has either a 3 or 4
channel receiver, depending on the model, the transmitters included with the
system are capable of transmitting 7 distinct signals. This allows you to program
each transmitter to more than one vehicle in two car families and also allows you
to change which button(s) control certain functions of the system.
(Example: Transmitter channel 5 can be programmed to activate Receiver
channel 2.)  Refer to the chart below for access to each of the transmitter channels,
and for the standard factory button assignments.

Released 7-17-01.

Some of the more common accessories for these additional channels are;

AS 9554

Remote Garage Door Interface

AS 9075

Remote car starter

AS 9153

Remote window roll up

AS 9256

Remote trunk release relay

TRANSMITTER

SYSTEM RECEIVER

CHANNEL

BUTTON

CHANNEL

FUNCTION

Remote Arm

1

1

Remote Emergency Panic
Remote Door Lock

Remote Disarm

2

2

Remote Emergency Panic
Remote Door Unlock/Unlock 2

3

3

4

&

4

5

&

5

6

&

6

RF Channel For Options

7

7

RF Channel For Options

All 3

Buttons

Single Push Pulsed Output for Optional Accessory
Or Double Push For Additional Optional Accessory

Single Push Pulsed Output for Optional Accessory
Or Push And Hold For Extended Output

Single Push Pulsed Output for Optional Accessory
Or Push And Hold For Extended Output

Summary of Contents for Pursuit PRO-OE3B3

Page 1: ...nnel 2 Refer to the chart below for access to each of the transmitter channels and for the standard factory button assignments Released 7 17 01 Some of the more common accessories for these additional channels are AS 9554 Remote Garage Door Interface AS 9075 Remote car starter AS 9153 Remote window roll up AS 9256 Remote trunk release relay TRANSMITTER SYSTEM RECEIVER CHANNEL BUTTON CHANNEL FUNCTI...

Page 2: ...rogramming for receiver s Lock channel 1 4 Press and hold the Lock transmitter button until the sounding device emits a long beep indicating the signal has been stored into memory 5 If you have additional transmitters up to 4 that need to be programmed repeat step 4 for each transmitter 6 Press and release the valet push button switch once 7 The dash LED will flash two times and the sounding devic...

Page 3: ...ransmitters up to 4 that need to be programmed repeat step 20 for each transmitter 22 Turn the ignition key off The sounding device will emit one short beep followed by one long beep indicating the system has terminated the program mode TRANSMITTERBATTERYREPLACEMENT You will notice a decrease in transmitter range as the battery condition deteriorates Transmitter battery replacement is recommended ...

Page 4: ..._______ 4 List model number of your actual transmitter pad as shown on page 4 of this manual _________________________ 5 The cost per transmitter is 65 00 6 Enter the total amount enclosed here ____________________________ New York state residents must include the appropriate sales tax 7 Method of payment check one of the boxes below Mastercard Visa Check or money order do not send cash Make check...

Reviews: