Page 4
VALET / SYSTEM OVERRIDE SWITCH:
The "Valet" switch allows you to temporarily bypass all alarm functions, eliminating the
need to hand your transmitter to parking attendants or garage mechanics. When the system
is in valet mode, all alarm functions are bypassed, however, the remote panic feature and
remote door locks will remain operational. To use the valet mode;
1. Enter the vehicle and turn the ignition key to the "on" position.
2.
Move the valet toggle switch to the "on" position within 10 seconds of step 1. The
dash mounted L.E.D. will turn on solid, and remain on as long as the system is in the
valet mode.
3.
To return to normal operation, move the valet switch to the "off" position any time
the ignition is on.
In the event you lose your keychain transmitter, or if the transmitter fails to disarm
the system, the valet switch can be used as a system override switch. Open the car
door (the alarm
will
sound). Turn the ignition key on, and move the valet switch to
the "on" position within 10 seconds. The alarm will stop sounding, and the vehicle
can now be started.
NOTE:
Always remember to move the Valet Switch back to the "off" position. This will
ensure that the vehicle remains protected at all times.
INTRUSION WARNING SIGNALS:
The system will inform you if an intrusion attempt has occurred while you were away from
the vehicle. If an intrusion attempt has occurred, the siren will "chirp" 4 times when
disarming the system.
The vehicle's parking lights will also flash 3 times to indicate an intrusion has occurred.
Enter the vehicle and observe the dash mounted L.E.D. for further information.
1. If the L.E.D. is flashing one time...pause...one time... etc., then an intrusion attempt was
made to a voltage sensing, light activated entry point, or to an optional sensor that has
been connected to zone 1.
2. If the L.E.D. is flashing two times...pause...two times...etc., then an intrusion attempt
was made to the hood, trunk, or an optional sensor that has been connected to zone 2.
3. If the L.E.D. is flashing three times...pause...three times...etc., then an intrusion attempt
was made through one of the vehicle's doors.
These intrusion warning indicators are stored in the system's memory, and will only be
erased from memory when the ignition key is turned on.