background image

Loading The Magazine Into The Changer

Completely slide the door on the changer to the 
right as shown in Figure 4.  Making sure the top of
the magazine is facing upward,gently insert it into
the unit until it clicks into place, as shown in
Figure 5. Slide the door of the changer fully closed
and the unit is ready for operation.

Removing The Magazine From The Changer

The magazine can be removed from the changer
using one of two methods as outlined below in
steps 1 and 2.

N O T E : Be sure to keep the door on the changer

closed at all times when not loading or 

removing the magazine. Leaving the door
open could allow dust, dirt and moisture to

enter the changer which could cause the
unit to malfunction.

1.During normal operation with power applied, 

slide open the door on the changer and press
the eject button as shown in Figure 6. The 
magazine will eject and can be removed.

2. If the magazinewill not ejectin a normal manner,

remove power by disconnecting the DIN cable

from the changer.

a. Slide open the magazine door. On the bottom

left rear of the changer, as shown in Figure 5,
peel off the tape covering the access hole;
insert a thin-bladed screwdriver into the
access hole and engage the mechanical 
release arm.

b. Lightly leverage the blade to the right and the

magazine will disengage and be ejected.

1 3

1 2

USE OF THE CD MAGAZINE

Fig. 1

Fig. 2

Fig. 3

Fig. 4

Fig. 5

Fig. 6

Manual magazine
release
(bottom left corner)

Eject button

Loading Disc Into The Magazine

This CD Changer uses a specially-designed maga
zine to hold up to 10 compact discs. To load discs
into the magazine, grip the tab on the magazine
tray into which you will be loading a disc and pull
it out gently as shown in Figure 1. Pull out only
one tray at a time. Insert a disc into the tray with
the label side down (play surface facing up) as
shown in Figure 2. Push the tray back into the
magazine as shown in Figure 3. Load discs into
the remaining 9 trays in a similar manner.

Removing Discs From The Magazine

To remove a disc from the magazine, pull out the
tray of the disc to be removed, lift out the disc,
and push the tray back into the magazine.

NOTES :

Avoid touching the playing side of the disc.

Only one disc can be inserted into each tray of 
the magazine. Do not try to insert more than one  
disc into each tray as damage to the discs and
magazine may occur.

This changer is not designed to play 3" CD-5
Single discs(8cm). Inserting a 3" disc into the
magazine, either with or without a 3"disc 
adaptor, can damage the changer and the disc. 
S u c h   d a m a g e   w i l l   n o t   b e   c o v e r e d   b y   t h e  
Warranty on this product.

For additional CD magazines, you may contact
us at www.asaelectronics.com

Summary of Contents for ACC56M











Reviews: