Wiring the Monitor
1.
Wire the Power Cable to the vehicle’s reverse lamp.
a)
Locate the reverse lamp in the tail light assembly. Using the tap
connector supplied, perform the following steps:
i.
Place the un-stripped positive lead wire on the run channel.
ii.
Insert the un-stripped red power wire completely.
iii.
Fold the tap connector back over the wires and make the
connection by crimping the u-contact down flush with the
plastic insulator.
iv.
Close the top hinged cover until latched.
b)
Attach the black wire to the ground.
i.
Place the un-stripped ground lead wire on the
run channel.
ii.
Insert the un-stripped black ground wire completely.
iii.
Fold the tap connector back over the wires and make the
connection by crimping the u-contact down flush with the
plastic insulator.
iv.
Close the top hinged cover until latched.
c)
Connect the RCA video connector from the existing camera to the
monitor cable.
d)
Connect the power supply plug from the existing camera to the
monitor power DC plug (if your camera has a power plug).
Tap Connection
5
