SUNILDA
ultra highend phono tube amplifier____________________________
Factory assembly & getting started
Once the amplifier has arrived at its desired destination, make sure the amplifier has ample time to
adjust to the climate at its new location. It is likely that the changes in temperature and humidity
between the last location and the new one, has caused condensation to build up somewhere in the
amplifier.
This can damage the device. Please allow the amplifier at least two hours to acclimatise.
The amplifier comes fully assembled, ready to go. The powercord should not be used as yet, please
connect all other input and output connectors first (cinchcables, speakercables, etc).
The device MUST be switched off while connecting it to other components, it might be damaged if this
is done with the amplifier under power. The person operating the amplifier might be hurt as well in this
case, since powerspikes, operating currents and voltage charges may occur!
Check whether the ON/OFF switch is in the OFF position. If so, you can now plug in the
powercord.
Use high quality cables only! Usage of DIY cables, low spec cables or cables intended
for other use voids all warranty and cancels any product liability. Make sure all plugs are connected
tightly to the amplifier. When in doubt, replace the cable.
Always use the device in a ’complete configuration’ , damages may occur when devices are not
connected to the amplifier when it is being run.
Never lift the device by its glass cover, not even when there are gripps attached to the cover. The
gripps and the cover are there for ornamental purposes only. They make the amplifier look nice.
The amplifier should be positioned at a level surface, in time the construction of the glass housing may
fail as a result of tensile forces.
Please disconnect and move the amplifier when you replace tubes. Replace them at a place where
you can work easily. You might damage the ’motherboard’ if you replace the tube in an awkward
position. After that please check all connectors. If all connectors are undamaged, make sure the
switch is in the OFF position, reconnect the powercord and swith the amplifier on. You can make sure
the amplifier is properly connected by checking the tubes. Only the inside of the tube should glow. If
the steel coverjacket glows as well, the device is faulty and must be serviced immediately.
As a rule of thumb the device should work now. Don’t push the volume up to its maximum just yet,
allow the device to burn in smoothly and avoid powerspikes.
The SUNILDA Pre-Amplifier needs at least a 1.6 Ampere slow blow circuit breaker in the fuse holder
for 230 VAC main voltage and 3,15 ampere slow blow by 115 VAC. Make sure your wall socket is equiped
in such a fashion.
