4
Set up
Your new phono pre amplifier ‘PAM V2’ should find its adequate place
onto a high quality rack or stable furniture. Please do not put the
‘PAM V2’ directly side by side to a loudspeaker or into the corner of the
room as there is to be found the highest acoustical energy. Also avoid
proximity of power amplifiers and mains filters.
Please plug the power cord into the mains socket at the back of the unit.
Connect the other end of the power cord to your wall outlet. The "hot"
pin of the power cord should be connected to the right pin (rear view) of
‘PAM V2's’ mains socket.
The power supply of your ‘PAM V2’ is equipped with a potted and
shielded 100 VA toroidal transformer and 40.000
m
F electrolyte capaic-
tors.
Two fast MOS voltage regulators clean up the secondary voltages. After
that the main voltages are controlled by eight fast and discrete MOS volt-
age regulators with accumulator-like characteristics. This provides a
separate power supply of highest precision for each section.
You have the opportunity to purchase an external power supply for your
‘PAM V2’. This power supply unit, called ‘EPS’ (
E
nhanced
P
ower
S
up-
ply), is to be connected to the ‘ext. Power’ socket at the back of your
‘PAM V2’ with the special cord provided with the ‘EPS’. You will then
have to unplug the power cord from your ‘PAM V2’.
Spatial separation between power supply and ‘PAM V2’ circuits less
influence on all components by the power supply will be gained. The
‘EPS’ should be placed at maximum distance to the ‘PAM V2’ to obtain
more musical substance.
Placing
Mains
Power supply
External power supply ‘EPS’