15
5.3.2 HighBit mode
Use the HighBit mode
only
if you want to transmit digital audio data
from the ART G3 to an Audionet pre amplifier compatible to the Audio-
net HighBit-Interface, e.g. the Audionet MAP V2 or Audionet MAP 1.
Additionally, in the HighBit mode digital output
OUT 3
11 transmits a
stereo PCM signal at a sampling rate of 96 kHz (downsampled from the
Audionet HighBit 192 kHz signal) with a resolution of 24 bit in the
AES/EBU format. Digital output
OUT 4
14 transmits even in the
HighBit mode a stereo PCM signal at a sampling rate of 44.1 kHz and a
resolution of 16 bit.
Important
·
With other devices but HighBit-compatible Audionet pre amplifiers a
correct decoding of digital audio data is
not
possible and can lead to
high-level noise from the speakers, which might damage your ear
and/or equipment.
In order to transmit digital audio data from your ART G3 to an Audionet
pre amplifier, you have to connect digital output
OUT 1
9 of the
ART G3 to the digital audio input '
Digital In 2
' of the MAP V2 or '
Digital
Audio IN 1
' of the MAP 1.
Additionally, connect digital output
OUT 2
10 of the ART G3 to digital
audio input '
Digital In 3
' of the MAP V2 or '
Digital Audio IN 2
' of the
MAP 1.
Important
·
Only if
both
connections are in place and the option
Set Digital
Output Mode
is set to
HighBit Mode
, you can transmit and re-
ceive digital audio data in HighBit mode (refer to section '
Set Digital
Output Mode
' on page 52)!
Important
·
If you do not need any of the digital outputs do not use any jumpers
to short-circuit the digital outputs. Instead, select
disabled
for op-
tion
Set Digital Output Mode
to switch off all digital outputs.
(refer to section '
Set Digital Output Mode
' on page 52).
