14
input for connecting CD players, DAT recorders etc. (refer to section
'USB/SPDIF digital audio input'
on page 16).
16
Digital input IN 2 (optical/TOSLink)
Audio input to connect digital devices (CD-Players, DAT recorders
etc) via optical fibre cable. This input is also available for the usage
of the D/A-converter.
5.3 Digital output formats
Important
·
In order to use digital outputs
OUT 1
to
4
of your ART G3, the op-
tion
Set Digital Output Mode
has to be set to either
LowBit
Mode
or
HighBit Mode
. If you selected setting
disabled
all digi-
tal outputs of the ART G3 are
switched off
(refer to section '
Set Digi-
tal Output Mode
' on page 52).
Please refer to the following table to determine which digital format at
which sample rate and resolution is available at the digital audio outputs.
The decision whether to use the HighBit or the LowBit mode depends on
the kind of digital receiver unit your ART G3 is connected to.
Digital Output
Mode
OUT 1 10
SPDIF
OUT 2 11
SPDIF
OUT 3 12
AES/EBU
OUT 4 15
optical
LowBit Mode
44.1kHz / 16bit
Stereo
PCM
44.1kHz / 16bit
Stereo
PCM
44.1kHz / 16bit
Stereo
PCM
44.1kHz / 16bit
Stereo
PCM
HighBit Mode
192kHz / 24bit
Stereo Upsampling
Audionet High Bit Mode
96kHz / 24bit
Stereo
Downsampling
PCM
44.1kHz / 16bit
Stereo
PCM
disabled
no signal
no signal
no signal
no signal
5.3.1 LowBit mode
Use the LowBit mode to connect the ART G3 with a component (digital
receiver) that has
no
Audionet HighBit-Interface. Referring to the table
below all digital outputs
OUT 1
9 to
OUT 4
14 transmit a stereo PCM
signal at a sampling rate of 44.1 kHz and with a resolution of 16 bit.
