Sealkid
SK 236/321/421/621
Description Sealkid
15
Quick Start Guide
1. Housing
2. Top bar with handle
3. Seal bar with sealing wire and PTFE tape
4. Silicone pressing rubber
5. Cutting knife
6. Control panel
7. Power cord
The sealer comprises a housing that contains electrical components. The sealing
wire with the PTFE tape is located on the top of the housing. When the top bar is
pushed down completely, the sealing wire is heated, thereby sealing the film. The
silicone pressing rubbers at the bottom of the top bar ensure the thorough
pressing together of both film halves. The film is cut to size using the cutting knife.
After the preset sealing time, the heating of the sealing wire will stop. After this,
the seal bar should be kept down (pressed down) for a short while before opening
the top bar to allow the seal to cool down; the film bag is now sealed shut.
4.3 Control panel
1. Rotary knob "Set sealing time"
2. Indicator light "Sealing"
Using the rotary button, the sealing time is set from 1 to 10. During the sealing
action, the red indicator light is on, indicating that the sealing wire is being heated.
After the preset sealing time, the heating of the sealing wire is automatically
switched off and the indicator light will go off as well.
Figure 4-2: Control panel
1
2
Summary of Contents for SEALKID
Page 3: ...3 Quick Start Guide...
