•
AudioCodes MP-124 FXS Patch Panel: Mount the Patch Panel in a 19-inch rack. Insert and fasten the
Patch Panel's 50-pin male connector to the MP-124 50-pin female Telco connector. Connect your
analog equipment to the Patch Panel using RJ-11 cables.
3.
Connect two 18-AWG wires to the DC terminal block (ensure correct polarity), and then secure the DC
terminal block to the MP-124 DC inlet. Connect the other end of the DC cable to a -48 VDC power
supply; The Ready LED first flashes amber and then turns green after initialization completes. The Lan
LED turns green indicating an Ethernet link.
4.
For desktop mounting, simply place MP-124 on a horizontal desk. For 19-inch rack mounting, refer to
the
Hardware
Installation Manual
.
5
Assigning an IP Address
Your MP-124 is shipped with a default IP address:
IP Address:10.1.10.10
Subnet: 255.255.0.0
Default Gateway: 0.0.0.0
To change the IP address:
1.
Unplug MP-124 from the network and reconnect the Ethernet port directly to a PC’s LAN port, using
an Ethernet crossover cable.
2.
Change your PC’s IP address and subnet mask to correspond with the MP-124 default IP address and
subnet mask (see above).
3.
In your Web browser, enter the default IP address of MP-124 (e.g., http://10.1.10.10); the MP-124
Web-based management tool opens, requesting your login credentials.
4.
Log in using the default (case-sensitive) username ("Admin") and password ("Admin"), and then click
Login.
5.
Access the Interface table (Configuration tab > VoIP menu > Network > IP Interfaces Table).
6.
Modify the IP address to correspond with your network IP addressing scheme, and then click Submit.
7.
Save your settings to flash ("burn") in the Maintenance Actions page (Maintenance tab >
Maintenance menu > Maintenance Actions); your Web browser disconnects from the MP-124 Web
interface.
8.
Unplug MP-124 from your PC and reconnect it to the network.
9.
Restore your PC’s IP address and subnet mask to their original settings, and then restart your PC and
re-access the MP-124 Web interface with its newly assigned IP address.
6
Configuring Basic SIP Settings
Configure MP-124 with basic SIP parameters using the Web interface:
To configure basic SIP parameters:
1.
In the Coders Table page (Configuration tab > VoIP menu > Coders and Profiles > Coders), configure
coders used by MP-124 that best suit your VoIP network and are supported by your VoIP provider.
