Audio RK2040, User Manual

Page: 9 / 14

flashing and the SET AF? line will commence flashing again. You can either
press the ‘
OK
’ button to change the setting again or press the ‘ ∧ ’ or ‘ ∨ ’ buttons
to scroll through the other available set-up options.
If the ‘
MENU
’ button is pressed while the top line is still flashing, the selection
will be cancelled, the display will return to the set-up menu (Fig:7) and the
previous AF setting will be restored.
If the rack is being controlled by Racktop, the AF level may display MUTED.
This can only be cancelled from the front panel if Racktop has not disabled
menu access.
SERIAL No
Pressing the ‘
∨
’ button while SET AF? is flashing will move to the next set-up
option screen, shown below:-
This line steady →
0 1 3 8 2 5 - 0 1
This line flashing
→
R X S / N .
Fig:9 SET-UP MENU, OPTION #3.
Notice that there is no ? following ‘S/N.’ on the bottom line. This is because
there is no option to change this parameter. The serial number is set into the
receiver during manufacture and cannot be changed. Wherever the set-up
option is
not followed by ?, the parameter cannot be changed.
Press the ‘
MENU
’ button to exit the set-up menu or press the ' ∨ ’ button to move
to the next set-up option screen, shown below:-
ON/OFF?
This line steady
→
R X O N
This line flashing →
R X O N / O F F ?
Fig:10 SET-UP MENU, OPTION #4.
This menu option allows you to turn off the power to the receiver. Press the
‘
OK
’ button to change to the power control screen. The display will change as
shown below:-
This line flashing
→
R X O N
This line steady →
R X O N / O F F ?
Fig:11 RX POWER CONTROL SCREEN.
Pressing the ‘
∧
’ or ‘
∨
’ buttons will alternate between RX ON and RX OFF.
In the normal operating mode, when a receiver is turned off, the screen will
only display the word OFF on the bottom line.
To restore power to the receiver, press the ‘
MENU
’ button to enter set-up mode.
This will take you directly to the RX POWER CONTROL SCREEN (Fig:11).