ADVANCED MANUAL / bit Ten /
42
7.
Before starting the
bit Ten
update, the software will present the following warnings:
-
do not disconnect the
bit Ten
from the PC;
-
do not disconnect the
bit Ten
from power supply;
-
temporarily disable the PC stand-by and energy saving features;
-
temporarily disable the PC screen saver;
-
close all running applications;
-
temporarily disable anti-virus and anti-spyware systems.
8.
Once you have clicked
OK
, the Firmware update starts. The updating
process will last from 30 seconds to 1 minute with the green progress
bar showing correct advancement.
WARNING
: During the updating process the progress bar could stop
for few seconds. Do not interrupt the process in any way.
.
9.
Once the update has been successfully completed, the window on the
right will appear. To use the
bit Ten
again, you have to exit the PC software
and the
bit Ten
will turn off.
10.
Start the
bit Ten
again and launch the PC software in
TARGET
mode.
If the
bit Ten
firmware update has completed correctly, the dialog
box will show the following indications:
-
new
bit Ten
firmware version.
11.
Repeat the
bit Ten
calibration procedure
(see 7.1 - 8.1)
.
9
