Audio A10-TX, User Manual

Page: 16 / 20

- 16 -
A10-TX User Guide
ª Phantom power can be activated only when the shell of the LEMO-3 is connected to pin-3 of
the LEMO-3 connector.
Battery Runtime Chart
There are many factors that will alter run times, including the mic in use.
This section’s chart shows approximate battery runtime in minutes based on the listed operation.
Operation
Battery Type
NiMH
(2450 mAHr)
Alkaline Lithium
(Energizer Ultimate)
recording only 18 hr 53 min 14 hr 26 min 33 hr 5 min
10 mW (RF Power Low) 8 hr 12 min 4 hr 7 min 12 hr 18 min
20 mW (RF Power Med) 7 hr 29 min 3 hr 56 min 11 hr 31 min
50 mW (RF Power High) 4 hr 33 min 2 hr 21 min 7 hr 57 min
recording only, 48 V 9 hr 47 min 6 hr 2 min 17 hr 44 min
50 mW, 48 V 3 hr 29 min 1 hr 33 min 6 hr 20 min
ª
The 48 V tests were run with a Schoeps CMIT Mini. Other settings used for tests to compile
the chart are: Low Cut Off, Limiter On, 40 dB gain (for 48 V)/30 dB gain (for Lav), freshly
formatted 8G card (16 hr record time), Bluetooth On, Blue LED On, and Brightness set to 5.
Certifications
Industry Canada Conformity
EN: This device complies with Industry Canada RSS-210. Operation is subject to the following
two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
FR :Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils
radio RSS-210. L’exploitation est autorisée aux deux conditions suivantes: (1) l’appareil ne doit
pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélec -
trique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
FCC Conformity
The A10-TX transmitter complies with the following requirements:
FCC (Federal Communications Commission) Part 74
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Changes or modification not expressly approved.
A10-TX frequency ranges supplied for use in USA:
• 470.2–547.8 MHz
• 518.2–607.4 MHz
ª Frequency range 608–614 MHz is forbidden for use in US.
ª
Warning! Any modifications or changes made to this device, unless explicitly approved by
Audio Ltd. may invalidate the authorisation of this device. Operation of an unauthorised