background image

8

Wireless Operating Frequencies

Frequency Selection

Each transmitter/receiver system operates on a single factory-aligned, crystal-controlled frequency.
Available frequencies are shown in the chart on the following page.

Operating frequency is specified by a two- or three-character code, such as “T2” or “12L,” in
addition to the actual frequency in MHz. The frequency of each transmitter appears on a label on
the outside of the unit. The frequency of each receiver appears on a label on the back of the unit
and the frequency of each system appears on the outer carton. For future reference, please record
them in the space provided below.

Because most of these authorized frequencies are shared with TV broadcasting, frequency selec-
tion is largely dependent upon which TV broadcast channels are in operation 

where the wireless

system is to be used.

RF Interference

If you encounter receiving interference (from other than an operating TV station), often it can be
eliminated by adjusting the receiver’s squelch control, as described on page 6.

Please note that wireless frequencies are shared with other radio services. According to Federal
Communications Commission regulations,“Wireless microphone operations are unprotected from
interference from other licensed operations within the band. If any interference is received by any
Government or non-Government operation, the wireless microphone must cease operation...”

If you need assistance with operation or frequency selection, please contact your dealer
or the A-T professional division.

Extensive wireless information also is available on the A-T Web site at www.audio-technica.com. 

For future reference, please record your system information here (the serial numbers appear
inside the battery compartment of each transmitter, and on the bottom of each receiver):

Operating Frequency

Freq. Code

Frequency

MHz

Receiver

Model

ATW-R03

Serial Number

Transmitter

Model ATW-T

Serial 

Number

Application

Freq. Code

Freq. (MHz)

• Traveling frequencies:

T2  

169.505

(Normally work anywhere in the U.S.A. and 

T3  

170.245

Canada, but as a result tend to be crowded.)

T8  

171.905

• For use only where there is no TV Channel 7:

7

I

176.200

• For use only where there is no TV Channel 8:

8M  

183.200

8S  

184.200

• For use only where there is no TV Channel 9:

9F 

187.600

• For use only where there is no TV Channel 10:

10C  

193.000

• For use only where there is no TV Channel 11:

11G  

199.800

• For use only where there is no TV Channel 12:

12L  

207.000

9

System Operating Frequencies

Summary of Contents for ATW-0327








Reviews: