Audio Technica AT-LP60, Installation And Operation Manual

Page: 8 / 24

Tips For Better Performance
Type Belt drive turntable, fully automatic
Platter Aluminum
Motor DC servo-controlled
Speeds 33 1 /
3
RPM, 45 RPM
Wow and flutter Less than 0.25% (WTD) @ 3 kHz (JIS)
Signal-to-noise ratio >50 dB (DIN-B)
Cartridge Integral Dual Magnet
™
stereo cartridge with diamond stylus
Output level
Pre-amp “PHONO” 2.5 mV nominal at 1 kHz, 5 cm/sec
Pre-amp “LINE” 150 mV nominal at 1 kHz, 5 cm/sec
Phono pre-amp gain 36 dB nominal, RIAA equalized
Power 120V AC, 60 Hz, 3W
Dimensions 360.0 mm (14.17") W x 97.5 mm (3.84") H x 356.0 mm (14.02") D
Net weight 2.98 kg (6.6 lbs.)
Furnished accessories Dual RCA (female) to 3.5 mm (
1
/
8
") mini-plug (male) stereo adapter cable; dual RCA (female) to 3.5 mm (
1
/
8
")
mini-plug (female) stereo adapter cable; 45 RPM adapter
Replacement stylus ATN3600L
Tips For Better Performance
• When opening or closing the turntable cover, handle it gently,
moving it either at the center or equally from both sides.
• Do not touch the stylus tip with your fingers; avoid bumping
the stylus on the turntable mat or a record’s edge.
• Clean the stylus tip frequently, using a soft brush with a
back-to-front motion only.
• If you use a stylus cleaning fluid, use it very sparingly.
• Wipe the dust cover and turntable housing gently with a soft
cloth. Use only a small amount of mild detergent solution to
clean the turntable and dust cover.
• Never apply harsh chemicals or solvents to any part of the
turntable system.
• Prior to moving the turntable, always unplug it from the AC
outlet and fasten the tone arm on the tone arm rest with the
vinyl twist-tie.
Specifications
8