Audio Technica AT-HA5050H, Instruction Booklet, Page: 19 / 52

19
* Please also read instruction manual of audio device.
* Be sure to turn off the power to each device before connecting.
* The USB terminal of this product is self-powered (does not require power from a computer).
1. With reference to "Connection example", connect a computer and other devices to be used.
2. Insert the power cable into the inlet on this product and 100V AC outlet.
3.
Turn on the connected devices.
4. Turn on this product. Wait until the power LED indicator turns from orange to green (about 60 seconds).
5.
Select the device for playback using the input selector switch.
6. After turning down the volume on this product, connect the headphone to the headphone output terminal. For more
information on headphone impedance and headphone terminals to be used, refer to "How to use headphone output
terminals."
* If a headphone is inserted or extracted with loud signal input to this product, the power indicator will turn orange temporarily and the
audio will be muted. This is not a failure; it is caused by the activation of the amplifi er protection circuit. A short time later (about 60
seconds), the volume will be restored to the original volume level.
* If your headphone has a 3.5 mm stereo mini plug, you will need to use a conversion plug adapter.
Please note that it may be diffi cult to pull some plug adapters out of the jack. See "Cautions" on page 16.
7.
Play the playback device and adjust to the desired volume level using the Volume knob on this product.
8. Adjust the volume and the VU meter range selector switch so that the VU meter's pointer is within the display range.
For more information, refer to "How to use a VU meter" (page 21).
* If you use the meter until the pointer goes off the scale, it may cause failure of the meter.
Connections
En
g
lis
h
Connection example